BPI-R3 SD card boot error

Banana Pi BPI-R4/BPI-R3 Mini/BPI-R3/BPI-R64/BPI-R2
1

*** U-Boot Boot Menu ***

 1. Startup system (Default)
 2. Upgrade firmware
 3. Upgrade ATF BL2
 4. Upgrade ATF FIP
 5. Upgrade SD partition table
 6. Upgrade single image
 7. Load image
 0. U-Boot console

Press UP/DOWN to move, ENTER to select, ESC/CTRL+C to quit Reading from 0x880000 to 0x46000000, size 0x200 … OK Reading from 0x880000 to 0x46000000, size 0x38dff8 … Fail *** Only 0x0 read! ***

Reading from 0x880000 to 0x46000000, size 0x200 … OK Reading from 0x880000 to 0x46000000, size 0x38dff8 … Fail *** Only 0x0 read! ***

MT7986>

2

Which image have you tried?

3

The problem has been solved by turning off the power and then disconnecting all connections (including the serial network cable) when booting with SD. Wait a few minutes and then power on again.

4

Which serial adapter do have used? Make sure it has 3v3 ttl level

5

I use the pl2303hx ta ch304g usb

6

At least these break wifi due to additional pullup

Not heared about boot issues yet and do not see it by myself…tried also ch340g

7

Thanks, I had this problem with the openwrt website, but the banana pie website provided no problem.