Banana Pi BPI-M2 Berry new Armbian image

Banana Pi BPI-M2 Ultra / BPI-M2 Berry
1

Armbian_23.02.0-trunk_Bananapim2ultra_jammy_edge_6.1.11_xfce_desktop.img 54183742b6eee409f19ebbcd3b08f3d

  1. About this image:

    • This release is for banana pi M2 Berry board, which is based on Armbian operation system with 6.1.11 kernel.
    • Note: Although this image shows M2 Ultra, it’s used for M2 Berry.

  2. Image link:

  3. Settings upon first startup: bcf6eccfa68510f98d9e7c9c344f900

More please see wiki page: https://wiki.banana-pi.org/Banana_Pi_BPI-M2_Berry

2

@Rookie Do you know if an Armbian image for Banana Pi R2 is available and where I can find it?

3

Does it work with A40i? It seems not to start up at all as there is one red signal and then shut down. It is as if the OS is not detected. Also, it seems that this image doesn’t create a visible BPI-BOOT partition at all to configure it.

4

Hello, @Rookie

I have problem with GPIO. I tried this wirringPi

And this

First error on install: /usr/bin/ld: wpiExtensions.o:(.bss+0x404): multiple definition of `comDat’; drcNet.o:(.bss+0x400): first defined here collect2: error: ld returned 1 exit status make: *** [Makefile:82: libwiringPi.so.2.44] Error 1

Second working in terminal, but not real change voltage on pins. (I tested all pins). obraz IMG_20230605_084911