Hello everyone,
Tried the OpenWRT MTK MP4.0 image from Banana Pi BPI-R4 | BananaPi Docs but luci was crashing / non responding after a few changes. So instead, i’m trying the Debian 12 image. BE14 does not get recognized. Does not show up in ip a. Any ideas? It’s connected, and sw4 turned on.
lspci:
root@BPI-R4 /root $ lspci
0000:00:00.0 PCI bridge: MEDIATEK Corp. Device 7988 (rev 01)
0000:01:00.0 Network controller: MEDIATEK Corp. Device 7990
0001:00:00.0 PCI bridge: MEDIATEK Corp. Device 7988 (rev 01)
0001:01:00.0 Network controller: MEDIATEK Corp. Device 7991
root@BPI-R4 /root $
Loading the mt7996e module:
[ 1001.774720] mt7996e_hif 0001:01:00.0: assign IRQ: got 123
[ 1001.780186] mt7996e_hif 0001:01:00.0: enabling bus mastering
[ 1001.786020] mt7996e 0000:01:00.0: assign IRQ: got 124
[ 1001.791135] mt7996e 0000:01:00.0: enabling bus mastering
[ 1001.852552] mt7996e 0000:01:00.0: attaching wed device 0 version 3
[ 1001.896774] platform 15010000.wed: WO Firmware Version: ____000000, Build Time: 20230218204509
[ 1001.955557] mt7996e_hif 0001:01:00.0: attaching wed device 1 version 3
[ 1002.204544] platform 15010000.wed: mtk_wed0: rx(0) dma enable successful!
[ 1002.244689] mt7996e 0000:01:00.0: HW/SW Version: 0x8a108a10, Build Time: 20240104162251a
[ 1002.244689]
[ 1002.336312] mt7996e 0000:01:00.0: WM Firmware Version: ____000000, Build Time: 20240104162245
[ 1002.373631] mt7996e 0000:01:00.0: DSP Firmware Version: ____000000, Build Time: 20231113135337
[ 1002.391572] mt7996e 0000:01:00.0: WA Firmware Version: ____000000, Build Time: 20240104162142
[ 1002.855708] mt7996e 0000:01:00.0: eeprom load fail, use default bin
[ 1002.867925] mt7996e 0000:01:00.0: registering led 'mt76-phy3'
[ 1002.876615] mt7996e 0000:01:00.0: registering led 'mt76-phy4'
[ 1002.886046] mt7996e 0000:01:00.0: registering led 'mt76-phy5'