BPI-M3 Gb Ethernet

Banana Pi BPI-M3
1

I’m using 2016-05-16-debian-8-jessie-mate-gpu-mpv-1080p-bpi-m3-sd-emmc image. I’ve installed ethtool to get information about eth0 interface. It shows 100 Mb/s speed. I tried to set to 1000 Mb/s, but not working. Does the Gb Ethernet working? Is it supported on this board+image?

2

this image will support gmac , please check your setting .

3

@sinvovoip Please Write down the steps how to enable gigabit Ethernet. I have changed the settings too, but Ethernet is only on 100mbit. Thanks

4

@sinovoip what kind of settings? how to setup Gigabit Ethernet? Shouldn’t it work out-of-the-box??

5

@BPI_Justin could you please provide the settings for Gigabit Ethernet on the M3 board with Debian Jessie image?